![]() My ABS juice is acetone and some ABS from an old computer case, the soft cream plate for blanking off unused disc drive slots. This has also happened once befor when I was using 3mm window glass, I changed to Borosilica glass thinking that it window glass was too brittle but the problem has not been solved. My ABS is sticking too well, the last print pulled away a thin section from the surface and has remained stuck to the bottom of the printed part. I will clean the glass with the first bottle and try again.Įdited 2 time(s). I tried both bottles for making the ABS juice, and both seemed the same. This is the bottle which I used to clean the glass. It also seems to evaporate slightly slowe. It smells the same as the other bottle, but it also smells like white spirit. The second buttle is called "Acetone, solvent for glues and varnishes" It does not smell like anything else which I know, so I guess it is actually acetone. The first one is called just "Acetone" and it has a wiping cloth picture on it I usually never use acetone, so I do not know exactly how it should smell. Neither have ingredients written on the bottles. Thank you for your have two bottles of acetone. However I could still see some lines, from the hairspray I think.ĭo you think it was still not clean enough? Should I have cleaned it with water instead, like you suggested? I cleaned the glass with acetone while cold, to get off most of the hairspray.Īfter heating to 115 degrees C, I cleaned it again and used a new paper towel (with acetone) about 5 times because when rubbing the glass.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |